cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Translate the entire conversation x

Model is Read Only conflict warning when saving assembly

ShandRonnie
6-Contributor
6-Contributor
‎Aug 06, 2012 02:06 PM
‎Aug 06, 2012 02:06 PM

Model is Read Only conflict warning when saving assembly

I am working with WF 5.0 M130, PdmLink 9.1


Is there a config.pro setting to suppress the warning pop-up "Model is Read Only" when saving assemblies that have some/all objects set to read-only?


Thanks in advance.


Ronnie Shand


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
0 Kudos
Notify Moderator
0 REPLIES 0
Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal

Contact Community Management
Top Tags