Place a symbol on a title block line - catch line doesnt work

[MP_9215870]

I want to place a symbol positioned on the upper line of my drawing title block, which is in a frame (A4,A3 ...)

But it seems Impossible to catch the upper line of this title block to snap with the position origin-point of the symbol.

Is there any solution to position this symbol exactly on my title blocks?

[tbraxton]

Have you used the snap to grid function? It is also possible to place a symbol in a cell of a drawing table.

[MP_9215870]

Yes, it works with the grid but i have always to switch on the grid snapping before I can place a symbol to the frame - it's not a perfect solution.

Wenn I place the Symbol in the Frame-drawing then I can not customize this symbol later in the drawing - at least I found no way to do it.