Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Sheetmetal corners : is it possible to use a user defined corner relief in flange feature ?

PhilippePradour
10-Marble

Sheetmetal corners : is it possible to use a user defined corner relief in flange feature ?

Hello,

The available corner relief in the SMT flange feature are V notch, rectangular, circular and oblong.

Is it possible to create custom corner reliefs via user defined corner reliefs, within the flange feature menu ?

Is there a config.pro option to allow this ?

Best regards,

Philippe

0 REPLIES 0
Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Top Tags