cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

a problem in updating parameters enclosed in symbols

CR_10169658
2-Explorer

a problem in updating parameters enclosed in symbols

I am using Creo Parametric Release 8.0 and Datecode8.0.3.0

I've created a symbol with parameters recalled inside and correctly saved and stored. But when I import the symbol in a 2D dwgs, parameters can't update but they remains with the construction &ptc_wm_version, &ptc_wm_revision etc.
If I use the same parameters outside the symbol (e.g. dwg frame or normal notes) they actually work and assume the value assigned to the parameters.

Here are the errors that I faced
N/A

ACCEPTED SOLUTION

Accepted Solutions

Hi @CR_10169658,

 

When adding the parameter in symbol, define the value of parameter under symbol attributes as &PTC_WM_VERSION.

 

 

 

 

I hope this will help.

Thanks.

 

 

View solution in original post

1 REPLY 1

Hi @CR_10169658,

 

When adding the parameter in symbol, define the value of parameter under symbol attributes as &PTC_WM_VERSION.

 

 

 

 

I hope this will help.

Thanks.

 

 

Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Top Tags