cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X

creating a mapkey which will ask for input only once while using and after that it will use that input for rest Of drawing.

skasaliwal
1-Newbie

creating a mapkey which will ask for input only once while using and after that it will use that input for rest Of drawing.

Hi everyone,

I want to create a mapkey which will ask for input only once while using and after that it will use that input for rest Of drawing.

For example, I want to create a mapkey which while using in drawing will ask once only Which Model You want to select(By using Pause command for mapkey) And afterwards for rest it will use that model for rest of modeling I.e. whenever I will use that mapkey it will Automatically set previously selected Model. If it is done It will be helpful for me to share this config file for customer who can then easily select their most used view According to drawing.

Thanxxx In advance For your Reply


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1
Chris3
21-Topaz I
(To:skasaliwal)

This is not possible without the use of external scripting or one of the APIs. Mapkeys only record what you do and then allow you to repeat the exact sequence again. There are no previsions for storing information in a variable.

Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Top Tags