cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about the Community Ranking System, a fun gamification element of the PTC Community. X

TW + ESP8288 Trainning

Telles
13-Aquamarine

TW + ESP8288 Trainning

I'm using a Trial version for training, as it contains PTCDefaultProject, which has been encouraging good results in other trainings. However in developer training https://developer.thingworx.com/en/resources/guides/connect-adafruit-feather/run-arduino-demo in step 3, the tutorial asks to create a Thing called ESP8266, this thing contains abstractions for this microcontroller. In Set-03, apparently a PTC removed this thing from their base, according to the same. I would like guidance on how to proceed, in this situation, if it is possible to download a mod or even the Thing itself to continue the training. Or even if there are other training for the same microcontroller and or ESP32.

ACCEPTED SOLUTION

Accepted Solutions
bchaudhary
17-Peridot
(To:Telles)

Hello @Telles ,

This will only appear if you have installed it properly at step 1.

 

Regards

Bhawna

View solution in original post

4 REPLIES 4
bchaudhary
17-Peridot
(To:Telles)

Hello @Telles , 

Did you successfully install the ESP8266 addon into Arduino IDE that has been mentioned in the step 1?

 

Regards

Bhawna

 

Telles
13-Aquamarine
(To:bchaudhary)

Hello, Bhawna.
  Yes, I got it!
  The problema is: where is the Thing called ESP8266, mentioned in step 3??

RT_10003402_0-1631098768359.png

 



Regards.
Telles.

bchaudhary
17-Peridot
(To:Telles)

Hello @Telles ,

This will only appear if you have installed it properly at step 1.

 

Regards

Bhawna

Telles
13-Aquamarine
(To:bchaudhary)

Hi, Bhawna.
The MCU config sdon´t create a Thing in TX, the MCU just send INFORMATIONS to.
I installed the MCU Board, like printscreen follow since before start this post.

RT_10003402_0-1631190173488.png


Regards.

Telles.

Announcements


Top Tags