cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Help us improve the PTC Community by taking this short Community Survey! X

Translate the entire conversation x

Design View and Manufacturing view has different revision.

K_Patil
10-Marble

Design View and Manufacturing view has different revision.

Hi, 

 

I have created a Part with design view, which is having revision -.1 

Then I have created a manufacturing view of same part, it has revision -.-.1 , which should be same as design view. 

 

Further, I independently created a part with manufacturing view, it has a correct revision -.1 

 

ACCEPTED SOLUTION

Accepted Solutions
avillanueva
22-Sapphire II
(To:HelesicPetr)

I am working this same conversion in my system. Linking my post:

https://community.ptc.com/t5/Windchill/Single-Level-View-Version-Conversion-Deprecation-and-warning/m-p/985989#M83123

Note that the conversion tool has been deprecated in the current version.

View solution in original post

2 REPLIES 2
HelesicPetr
22-Sapphire II
(To:K_Patil)

Hi @K_Patil 

The behavior is old multilevel revision schema. Your system has been upgraded from previous version where the multilevel revision schema was a standard.

In new versions 10.0+ a single revision schema is used.

Your actual behavior is normal if the system is not converted to new single revision schema usage. 

Following article describes your situatiuon

CS79141 - Why new containers still use the the old multi-level versioning schema

Hope this can help you. 

PetrH

avillanueva
22-Sapphire II
(To:HelesicPetr)

I am working this same conversion in my system. Linking my post:

https://community.ptc.com/t5/Windchill/Single-Level-View-Version-Conversion-Deprecation-and-warning/m-p/985989#M83123

Note that the conversion tool has been deprecated in the current version.

Announcements

Top Tags