FMEA Tool Tip

[ptc-6333065]

When adding a new Mode into a FMEA Worksheet how can i select certain columns to 'merge and center' the data in that feild without adding another line/row?

Any information will be uselful many thanks.

[JosephMay]

Kallum, could you be a little more specific? You refer to adding a new mode, but wish to not add another line/row. Could you provide an example?

[ptc-6333065]

Hi thank you for the reply

i have attached the following screen shot as a example. as you can see some colums are merged through the rows while others are not in particalur column 1 and 2. how can i get colunm 2 to appear the same as column 1

[JosephMay]

I would check your FMEA Data Structure. Currently our FMEAs are set up as you have desired and the structure is "Standard FMEA".

[ptc-6333065]

thanks any chance you could provide the path to this set up i am a faily new user of the programme

[JosephMay · Accepted solution]

Sure.

- With your Project open, open the Project Navigator. You can "pin" the Navigator so it remains visible.

- Expand "Support Files"

- Expand "FMEA"

- Open "Design". You should see the "FMEA Design" window with all the FMEA fields listed.

- At the top of your screen, on the menu bar, select "Design"

- You should see a dropdown window: "Setup Structure". Select this.

- the "Select FMEA Data Structure" window should open:

Note: If another user makes any changes, you will need to refresh your FMEA module.

Hope this helps.