cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

how to get rid of the ghost file in whindchill?

Highlighted
Newbie

how to get rid of the ghost file in whindchill?

hi, there


I often encountered a ghost file issue (see Figure1) when I was checking in the files which had been done.


1. Actually, when i checked out the assembly drawing into the workspace, there was no one ghost file in workspace.


2. After i did some changes about the assembly drawing and saved it, then the ghost shown up.


3. when i succeeded in checking in them, the ghost file disappeared and had not been checked in.


when i make any changes in the drawing next time, they will show up again.



Is there anyone who can give me a clue?


thanks

1 REPLY 1

RE: how to get rid of the ghost file in whindchill?

hi,you guys,


thank you so much.


I make it, here are the steps.


I`m sure that were caused by some improper references.


We have to pay more much attention on these:


circular references


unused substitute object dependencies


interchange dependencies