roll back new part

[DCG]

I have a user who would like to roll back a new part to yesterday.  It is new, so never checked in.  Is there a way to roll back a new part in a Workspace?

[BenLoosli]

Not directly.

The  user workspace only contains 1 copy of the file.

There maybe an unreferenced iteration in the upload cache folder. but finding it would be a needle in a haystack search.

This is assuming that you have upload with save turned on.

Alos their local cache may have an iteration, but those are even harder to find.

[DCG]

Upload with save is turned on.  But the version always shows as 1.1 for a new part.  

I didn't think there was a way but seems like it should be easy for Windchill to do this with a new part.  

[HelesicPetr]

Hi @DCG 

It is possible just only if you have set preference Workspace Frame Stack Size 

Default is zero.

Then you can go back rollback last numbers of saves. 

PetrH

[DCG]

Thank you PetrH.  That rolls back the entire Workspace.  I'm looking to roll back just one part (that's not even checked in yet).  Seems simple enough, but impossible to do.  

[HelesicPetr · Accepted solution]

@DCG 

You're right,

It revert the workspace, but after the reverse you can pickup your part, save them locally and then revert the workspace back and open/save the part in old state.

And yes, it is not possible to revert just one part from ws a way you would like to.

PetrH

[DCG]

That is a good trick!  I'll have to try it next time.  Have you ever had trouble going forward in frames after going backward?

[HelesicPetr]

Hi @DCG 

No, I have no issue with the frames if the frame limit is under 100 frames. 

If the value of the frames is more then 100 then I have had experience with performance issue .

PetrH