Assumption in assembly mode problem !

[mfontaine]

(sorry for my english )

Since i upgraded from creo 2.0 m60 to m130

I realize in assembly mode when i what to add a new part.

I need to click the ok button and re-click on edit definition to have the choice to use the allow assumption checkbox

Looks when you insert the part for the first time it's not allow, just make no sense for me.

Everybody at my office using creo have the same problem.

Thanks

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[StephenW · Accepted solution]

Check for the config.pro option:

comp_placement_assumptions YES

I'm on M120 and it doesn't have this problem.

[mfontaine]

Yeah it's working

Thanks