Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
Normally, when you create a hole (using Hole) at the assembly level, it creates an assembly cut - the hole feature is not propogated to the part, so when you open the part by itself, it will not have a hole. Is there an option that allows IFX to duplicate this functionality?
Solved! Go to Solution.
Could you please mark this as solved.
You can set the following values for HOLE_VISIBILITY
Never mind. I found the HOLE_VISIBILITY option
Could you please mark this as solved.
You can set the following values for HOLE_VISIBILITY