Can you have multiple drawing views each with its own simplified rep all derive the balloons from one table?

[tbarlag]

Can you have multiple drawing views each with its own simplified rep all derive the balloons from one table?

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[AmitDeshpande]

Hi Todd,

No, this is not possible.  The drawing view, repeat region table and BOM balloons are all connected and parametric.

The BOM balloons will show on the drawing view, based on the information from the repeat region table.  If the information on the repeat region table is modified, the balloons will update.

You need one table for each view, to show the BOM balloons.

Thanks,

Amit

[Chris3]

Yes it is possible but it is not supported.

See here:

Allow BOM Ballons from Master Rep Repeat Region to be displayed on Simplified Reps

[StephenW]

Chris,

Does this still work in Creo 3?

[StephenW]

Oh wait, there it goes. Menu manager was popping up behind.

[huggre]

Amit

Can please you clearify why this is not possible?, this is way we typically create a detail view of a single component within an assemly drawing; with balloon.