Skip to main content
T
tbarlag1-Visitor
1-Visitor
September 13, 2016
Question

Can you have multiple drawing views each with its own simplified rep all derive the balloons from one table?

  • September 13, 2016
  • 3 replies
  • 2752 views

Can you have multiple drawing views each with its own simplified rep all derive the balloons from one table?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

3 replies

A
AmitDeshpande18-Opal
18-Opal
September 13, 2016

Hi Todd,

No, this is not possible.  The drawing view, repeat region table and BOM balloons are all connected and parametric.

The BOM balloons will show on the drawing view, based on the information from the repeat region table.  If the information on the repeat region table is modified, the balloons will update.

You need one table for each view, to show the BOM balloons.

Thanks,

Amit

C
Chris321-Topaz I
21-Topaz I
September 14, 2016

Yes it is possible but it is not supported.

See here:

Allow BOM Ballons from Master Rep Repeat Region to be displayed on Simplified Reps

S
23-Emerald III
StephenW23-Emerald III
23-Emerald III
September 14, 2016

Chris,

Does this still work in Creo 3?

S
23-Emerald III
StephenW23-Emerald III
23-Emerald III
September 14, 2016

Oh wait, there it goes. Menu manager was popping up behind.

H
huggre1-Visitor
1-Visitor
September 14, 2016

Amit

Can please you clearify why this is not possible?, this is way we typically create a detail view of a single component within an assemly drawing; with balloon.

Terms & ConditionsCookie settingsAccessibility statement