Center Mark - Uniform Sizing?

[doneill]

Is there a way I can easily adjust the size of a Center Mark on my Creo 4 drawing besides dragging each endpoint individually?  

Thanks

[rzukowski]

Under the annotation tab, select the center mark.  Then move your cursor to the intersection of the centerlines and drag from there.  This will drag all four ends at once.

[doneill]

When I move my cursor to the intersection and try to drag, all I get is a selection box...

[MartinHanak]

Hi,

please attach a picture describing your "situation".

[doneill]

[kdirth]

Select the center mark then position pointer over one of the lines of the center mark and drag the line out from the center to adjust all four ends together.

[doneill]

Thanks for the reply... I did what you say but all I get is the selection box, as you can see in the picture above.  

[StephenW]

Once you select the axis (single left mouse button click), you should be able to move the mouse back over the axis and you'll get the 4-arrow pointer, then you can LMB click and hold that will move all of them.

[MartinHanak]

---

@StephenW wrote:

Once you select the axis (single left mouse button click), you should be able to move the mouse back over the axis and you'll get the 4-arrow pointer, then you can LMB click and hold that will move all of them.

---

Just additional note ...

in doneill's drawing following option is set ... axis_interior_clipping  YES

[StephenW]

Ah, I've never used that option, axis_interior_clipping. That makes a mess of my process. I see the same "selection box" as Doneill when that option is set IF I try to select the very center of the axis but I can adjust the "exterior" axis endpoints all at once if I move the mouse over the exterior portion of the axis.

[doneill]

One other thing I noticed... if I leave my Drawing Properties with axis_interior_clipping set to YES... I can double click the axis, turn on the axis label and I get a handle at the center of the axis and the 4-arrow pointer.  For whatever that's worth...

[doneill]

Thanks for the help everybody!

[doneill]

Yeah... I was not getting the 4-arrow pointer until I changed Drawing Properties... axis_interior_clipping to NO.