cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Change Pattern

SOLVED
Matteo_1987
Alexandrite

Change Pattern

Goodmorning everyone,
is it possible to release a series after it has been made in such a way as to modify every single feature that has been created with the same series?
As you can see in the attachment I have made a series of numbers.
I would need to release the series in order to change the number.
Or is there a way to do this?

 

ty,

matteo

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Change Pattern


@Matteo_1987 wrote:

Goodmorning everyone,
is it possible to release a series after it has been made in such a way as to modify every single feature that has been created with the same series?
As you can see in the attachment I have made a series of numbers.
I would need to release the series in order to change the number.
Or is there a way to do this?

 

ty,

matteo


Hi,

please read

https://community.ptc.com/t5/3D-Part-Assembly-Design/Pattern-numbers/td-p/122932 

https://support.ptc.com/appserver/cs/view/solution.jsp?source=Sitecore Article Viewer&art_lang=en&n=... 

https://community.ptc.com/t5/Part-Modeling/text-repetition/m-p/697310 

 


Martin Hanák

View solution in original post

4 REPLIES 4

Re: Change Pattern

In the past when I've made scales like this to indicate angles, positions, etc. I wanted something like this, too.

In the end I was only able to define the scales with a sketch that defined all the tic marks, and individual TEXT definitions for labels. It's tedious, but then again, it's not the only such limitation I've had to deal with.

Re: Change Pattern


@Matteo_1987 wrote:

Goodmorning everyone,
is it possible to release a series after it has been made in such a way as to modify every single feature that has been created with the same series?
As you can see in the attachment I have made a series of numbers.
I would need to release the series in order to change the number.
Or is there a way to do this?

 

ty,

matteo


Hi,

please read

https://community.ptc.com/t5/3D-Part-Assembly-Design/Pattern-numbers/td-p/122932 

https://support.ptc.com/appserver/cs/view/solution.jsp?source=Sitecore Article Viewer&art_lang=en&n=... 

https://community.ptc.com/t5/Part-Modeling/text-repetition/m-p/697310 

 


Martin Hanák

View solution in original post

Re: Change Pattern

This is really cool. Next time I need to make a scale on a piece of equipment I'm going to come looking for this so I can make it the smart way, not as a dumb feature.

Re: Change Pattern

It is possible for Creo to do this. The key concept is to use a parameter defined in a feature relation for each text value in the pattern. This relation needs to precede the pattern feature so that it can be used when generating the pattern. @MartinHanak  provided relevant references to see how to do it.

Announcements