cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Changing Dimension Tolerance Mode

msteis
12-Amethyst
12-Amethyst
‎Nov 06, 2013 10:30 AM
‎Nov 06, 2013 10:30 AM

Changing Dimension Tolerance Mode

I'm kind of stuck with this as I haven't ever used it. In Creo 2.0, how do you change the tolerance mode on a particular dimension as shown below? My option is grayed out.

 

Capture.JPG

 

Thanks,

 

Matt


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
0 Kudos
Notify Moderator
2 REPLIES 2
ScottWyatt
2-Explorer
2-Explorer
(To:msteis)
‎Nov 06, 2013 12:00 PM
‎Nov 06, 2013 12:00 PM

There is a config.pro option and a drawing detail option called "tol_display". I recommend setting the default to both of those to "yes".

Notify Moderator
msteis
12-Amethyst
12-Amethyst
(To:ScottWyatt)
‎Nov 07, 2013 07:31 AM
‎Nov 07, 2013 07:31 AM

I'll give it a try Scott. Thank you.

Matt

0 Kudos
Notify Moderator
Announcements
NEW Creo+ Topics: Real-time Collaboration


Contact Community Management
Top Tags