Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
I want to make a note display certain text depending on a dimension of a part. I'm guessing it is a basic if statement somewhere, I just don't know where to put it.
Ex:
if d1:0 = .375
"display this text in a note"
endif
Solved! Go to Solution.
You put it in the relations. The relations then creates a parameter which you call out on the drawing with &NOTE
IF d0 == .375
NOTE = "YEAH IT WORKS"
ELSE
NOTE = "NOPE IT DOESN'T"
ENDIF
You put it in the relations. The relations then creates a parameter which you call out on the drawing with &NOTE
IF d0 == .375
NOTE = "YEAH IT WORKS"
ELSE
NOTE = "NOPE IT DOESN'T"
ENDIF
That worked, thank you!