Corner Relief

[wfalco]

Anyone have a tutorial on corner relief feature? Can't seem to find. See
attached.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[A.DelNegro]

You mean you can't figure out how to use the feature with the information provided in the help manual?

Go figure...

[jbennett]

Have you tried looking at the PTC learning exchange? There are a lot of good tutorials, not sure if there is one on what you are looking for, but it is at least a place to look.

[wfalco]

Ha Ha. Actually I have not looked - but was hoping not to. My eyes will
go cross. A good demo goes a long way....especially from someone - who
not only can do it - but can share the good the bad and the ugly.

[wfalco]

I will look. I saw one for Creo2. But would like to see WF4 version.
Thanks!