cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Stay updated on what is happening on the PTC Community by subscribing to PTC Community Announcements. X

Corner Relief

wfalco
15-Moonstone

Corner Relief

Anyone have a tutorial on corner relief feature? Can't seem to find. See
attached.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
5 REPLIES 5
A.DelNegro
4-Participant
(To:wfalco)

You mean you can't figure out how to use the feature with the information provided in the help manual?

Go figure...


jbennett
3-Visitor
(To:wfalco)

Have you tried looking at the PTC learning exchange? There are a lot of good tutorials, not sure if there is one on what you are looking for, but it is at least a place to look.

wfalco
15-Moonstone
(To:wfalco)

Ha Ha. Actually I have not looked - but was hoping not to. My eyes will
go cross. A good demo goes a long way....especially from someone - who
not only can do it - but can share the good the bad and the ugly.


jbennett
3-Visitor
(To:wfalco)

wfalco
15-Moonstone
(To:wfalco)


I will look. I saw one for Creo2. But would like to see WF4 version.
Thanks!

Top Tags