cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Create model parameter from Model check report

ssharma-6
2-Explorer

Create model parameter from Model check report

I want to create a parameter for overall size of the parts and I know that value of overall size can be seen in Modelcheck report (with setting in MC configurator).

However I don't know how to link Modelcheck report values to the model parameters, there must be some setting within Modelcheck configurator but I am unable to find it.

Please help !

4 REPLIES 4
huggre
12-Amethyst
(To:ssharma-6)

Search for ADD_CHK_PARAM in the Modelcheck user guide.

This will allow you to create a parameter that stores the outcome of another check.

(Not sure if it woks for model size, havent tested it)

In my company we capture the outer x/y/z dimensions of a part by referencing exisiting model dimensions in a set of relations that writes the result to a designated string parameter.

You can also use a note parameter to do the same, however, as far as i know, note parameters can not be designated if that is a requirement.

jforsyth
14-Alexandrite
(To:huggre)

Where can I find the Modelcheck Users Guide?

llie
16-Pearl
(To:jforsyth)
jforsyth
14-Alexandrite
(To:llie)

Thanks,

 

That worked.

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags