Does anyone know if it is possible to create your own lattice types in Creo? The "Custom" and formula-based options weren't quite what I hoped from the names. Yet I am surprised that even some very common standard lattices aren't included by default. In particular, I would like to be able to make log-pile and octet-truss lattices.
Any advice anyone might provide on how to make Log-pile and Octet-truss lattices in Creo would be greatly appreciated!
ACCEPTED SOLUTION
Accepted Solutions
In earlier releases, there is little flexibility to support cell types that you create. In Creo Parametric 6.0.0.0 you can create a lattice, based on a Creo part file, where the cross sections of opposite faces of a cube are the same, and the geometry is a full boundary representation (BREP). This
In earlier releases, there is little flexibility to support cell types that you create. In Creo Parametric 6.0.0.0 you can create a lattice, based on a Creo part file, where the cross sections of opposite faces of a cube are the same, and the geometry is a full boundary representation (BREP). This
