Creo 1.0 site issues

[BillChapman]

We are having intermittent issues with Pro NC not transferring the site file setting into nc sequences. It will work OK for one operation and then stop working on the next. Started after going to Creo 1.0. We are running Win7 64.

The site is always defined and active, the parameters are just not getting into the nc sequences consistently.

Any suggestions, or just a bug PTC needs to work out?

Regards,
Bill Chapman
Sencon



This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[BarryS]

Bill,

We are having the same issue with Creo 1.0 M030 (Win7 64), no solution
yet.

Barry

[DanielSantos]

I've seen the same problem here... but had no time to report or
reproduce it yet... it's seems to be intermittent...



Also, if you are creating toolpaths using process manager, the
visibility settings are not respected. It is a confirmed bug - SPR
#2111748



Win 7 64 here too, but I've this in Win 7 32 and XP both architectures
too...



I hope someone could report it to PTC,



Best



Daniel

[DanielSantos]

By the way:



WF5 M120 here....



From: Santos, Daniel (GE Oil & Gas)