Hi Guys,
I downloaded the trial version of Creo, installed it and Parametric doesn't run. ModelCHECK launches and appears to run. Quality agent runs (info pasted below) but when I try and run Parametric, nothing happens.
Is there an error log somewhere I can check?
System info:
Hardware Information
Manufacturer Dell Inc.
Platform Type
System Latitude E6320
Processor Manufacturer GenuineIntel
CPU Number Of Cores 2
Speed Mhz 2501
L2 Cache Kb 256
RAM MB 4096.00
3GB Switch true
SWAP GB 3.88
DISK Label C:
Size GB 127.01
Available GB 45.07
FileSystem Type NTFS
DISK Label 😧
Size GB 105.10
Available GB 37.11
FileSystem Type NTFS
OS Information
OS Name Microsoft Windows 7 Professional
Vendor Microsoft Corporation
Version 7601
Locale 1009
Indexing Services OFF
Animate Controls ON
Animate Windows ON
Fade Menus ON
Graphics Information
Name Intel(R) HD Graphics Family
Vendor Intel Corporation
Version 8.15.10.2418
Screen Resolution 1366 x 768
System Colors 32
AERO Enabled ON
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
