Hi everyone,
I was just designing a railway passenger bogie.
What will be the best method to draw in Creo 2.0 parametric
I was thinking of beam elements are to be used o/ r extrusion of part.
Attached is sample picture.
Will expert guide how to draw assembly so that it can run with loading analysis.
Thanks,
Dhiraj
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
