I have a top view of a component, that I want to show in a P&ID drawing. All I want is a 2D sketch since everything else is 2D.
I opened up the part, made a drawing with the top view I want, and converted the view to draft entities. I can select the sketch mode in the drawing and copy the draft entities, but can't seem to use them in a sketch for curves in a part.
Is there a way to do this?
What I want to end up with is a set of parametric curve entities that I can manipulate as needed.
I'd rather not do this as draft entities in a drawing.
This is what the item looks like.
[cid:image001.png@01CF7E3C.37CDDE90]
I know it's simple enough to sketch, but I was hoping for an easier method.
David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.