cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Eliptical helical sweep to swept blend? Help please

ptc-5314720
1-Newbie

Eliptical helical sweep to swept blend? Help please

Firstly, is there a way to strech a helical sweep so that it is eliptical rather than round?

 

Also, is there a way to make a smooth transition between the end of a helical swep and a the start of a swept blend?

 

Thanks.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

You might try wrapping a sketch around an elliptical surface.

Otherwise, not perfectly helical is a method by which you intersect a helical surface with the elliptical surface and use the intersection as an origin guide.

And there was a sheetmetal solution posted by PTC at one time to map a curve onto a flattened sheetmetal part and bending it back. However, that might not be easy with a elliptical shaped sheetmetal part.

Announcements