cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Features stopped snapping to references?

TomD.inPDX
17-Peridot

Features stopped snapping to references?

What-up!

I have something set in config.pro where sketch features stop snapping to references.

What could be set to cause this problem? Bug?

Creo 2.0

The config.pro file is attached.

Load the config.pro in a dummy folder and set this dummy folder as a start directory in the creo shortcut.

Start Creo and create a new part and select any datum for a sketch.

Try attaching a line or rectangle to the two reference lines. I get no snapping joy when I do this.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
ACCEPTED SOLUTION

Accepted Solutions

Antonius,

remove sketcher_rel_accuracy 0.00001 option from you config.pro.

Martin Hanak


Martin Hanák

View solution in original post

4 REPLIES 4

Antonius,

remove sketcher_rel_accuracy 0.00001 option from you config.pro.

Martin Hanak


Martin Hanák

Interesting. I would have never guessed but that worked. Is it a bug?

Is it a bug or not ? That is the question ...

If you have a courage you can ask PTC support .

Martin Hanak


Martin Hanák

Submitted as Case #10885254

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags