cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Hole with embedded datum axis

JTebbe
4-Participant

Hole with embedded datum axis

Can someone help me with the attached snippet from the CREO 3.0 training? When I click "Hole" from the Engineering group, I don't see "Datum" or "Axis". Is it on a different tab?

1 ACCEPTED SOLUTION

Accepted Solutions

The "Datum" group is on the far right side of the dashboard. By default it's minimized and looks like this:

creo3_datum_dashboard.png

But it may also be ungrouped and then looks like this:

creo3_ungrouped_datum_dashboard.png

I don't think you may hide it completely, but if you don't have it, you may always go back from Hole tab to Model tab and the Datums tools will still be available for use.

View solution in original post

1 REPLY 1

The "Datum" group is on the far right side of the dashboard. By default it's minimized and looks like this:

creo3_datum_dashboard.png

But it may also be ungrouped and then looks like this:

creo3_ungrouped_datum_dashboard.png

I don't think you may hide it completely, but if you don't have it, you may always go back from Hole tab to Model tab and the Datums tools will still be available for use.

Top Tags