The community will undergo maintenance on October 16th at 10:00 PM PDT and will be unavailable for up to one hour.
Hello
How we could create dimension using common reference in Creo 6 ( in the attached figure it shows for Creo 2)
Thanks
Solved! Go to Solution.
In Creo 4.0 and probably the same in 6.0, select the base reference, then, holding control key, select all other references before placing dimensions.
Dimension - Common references is o more available as it was merged in Dimension from Creo 3.0. You need to use CTRL for such dimensions.
In Creo 4.0 and probably the same in 6.0, select the base reference, then, holding control key, select all other references before placing dimensions.
Thanks, yes it needs to select other references while holding the control key before finishing dimensions placement.