cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you know you can set a signature that will be added to all your posts? Set it here! X

How to create Dimension with Common reference in Creo 6

MohaSharifi
6-Contributor

How to create Dimension with Common reference in Creo 6

Hello

 

How we could create dimension using common reference in Creo 6 ( in the attached figure it shows for Creo 2)

 

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
kdirth
20-Turquoise
(To:MohaSharifi)

In Creo 4.0 and probably the same in 6.0, select the base reference, then, holding control key, select all other references before placing dimensions.


There is always more to learn in Creo.

View solution in original post

3 REPLIES 3

@MohaSharifi 

Dimension - Common references is o more available as it was merged in Dimension from Creo 3.0. You need to use CTRL for such dimensions. 

kdirth
20-Turquoise
(To:MohaSharifi)

In Creo 4.0 and probably the same in 6.0, select the base reference, then, holding control key, select all other references before placing dimensions.


There is always more to learn in Creo.
MohaSharifi
6-Contributor
(To:kdirth)

Thanks, yes it needs to select other references while holding the control key before finishing dimensions placement.

Top Tags