How to cross check after IDD ??

[pkamble]

Hello,

I have corrected a model using IDD Is there any way to check that the model created has same topology as that of the original one !?

Message was edited by: pradeep kamble

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[James62]

Hi,

It's difficult to tell as it depends on each case. Sometimes analytic surfaces change their topology to non-analytic, and that is why you should always freeze the specific node you work on upfront.

To see if the topology has changed i usually look at the surfaces isolines which are off by default.

[pkamble]

Thank you James