Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hi,
Hoping someone can help me a bit with modelling hydraulic pipes on Creo1,I don't seem to be able to activate the follow command to make the pipe follow an axis through a hose clamp. Other thing I seem to have forgotten to do is how to define the length of a segment to allow for an assembly which is moving.
Thanks in advance, hope someone can point me in the right direction.
In Reply to Stephen Whyte:
Hi,
Hoping someone can help me a bit with modelling hydraulic pipes on Creo1,I don't seem to be able to activate the follow command to make the pipe follow an axis through a hose clamp. Other thing I seem to have forgotten to do is how to define the length of a segment to allow for an assembly which is moving.
Thanks in advance, hope someone can point me in the right direction.