Part must become assembly, any way to save the drawing?
Hi all...
I have a part & fully detailed drawing that now must become an assembly. A particular feature on this injection molded plastic part is now going to become a insert molded metal part. I know I am reaching here, but is there a way to make the part an assembly & save the drawing? Or do I bite the bullet & detail the whole thing again?
Thanks, Joe S.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
We run into this with sheetmetal all the time. In a word, no, you're restarting. If you don't mind leaving the detail on the drawing and adding just the assembly, you could do that, but that's about the reach of what you can do.
