I have a model which for some reason the Pro_mp_mass isn't updating to the correct values. Whe I run a mass property calc I get the correct figure but for some reason it is not going through to the pro_mp_mass.
I also have an assembly with some assembly cuts in it which isn't going to full green in the traffic light however everything seams fine with all of the models and features.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
File -> Prepare -> Model Properties -> Mass Properties--Change -> Generate Report...
Ridiculously convoluted, I know. If you don't want to have calculation set to automatic (can slow down regen of large models and assemblies) then it's worth writing a mapkey for the 'report' - ours is MP.