cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Publish Geometry/Copy Geometry

MohaSharifi
5-Regular Member

Publish Geometry/Copy Geometry

I have a problem with publish geometry and copy geometry when publishing a quilt. When I am in the middle of design tree and create quilts for material removal (solidify) and use a publish geometry with the same quilt on the other part, I see an error. When I roll back the master model to the publish geometry and regenerate the slave model the error gone and model regenerates. How I can resolve this problem?

I attached the models and pics to show the problem.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
3 REPLIES 3

Instead of direct Publish Geometry first copy desired geometry and then in Publish geometry use that Quilt.

As in your case desired geometry defination is wipedout due to cut or protrude.

I hope this will serve your purpose.

The publish geometry feature does not publish the geometry as it exists at that point in the model tree.  It publishes the geometry as it exists at the end of regeneration. That's why you get different results in insert mode vs. full regeneration.

If you need it at a certain point in the regeneration process, do as suggested above, make a copy at that point and publish the copy instead.

I always put my publish geometry features in the footer to reinforce that fact.

--
Doug Schaefer | Experienced Mechanical Design Engineer
LinkedIn
MohaSharifi
5-Regular Member
(To:MohaSharifi)

Thanks for both of you. I used copy command to create a surface at the end of design tree to create a copy geometry at the footer. But I need to do more work on the slave part to make the quilt as a closed area to create a solid feature ( please see the attached parts). Actually I wanted to use these techniques to have core or cavity of the cast part for using on the outside of that part. Do you know a better method for this purpose ( I create the core of the cast part within the part to have all the data in one place).

Announcements