Ref Dim mapkey *(uses a temp view named 'w')

[eslotty]

The WF4 mapkey here works but was a bear to make consistent.... It
doesn't work with an active part in an assembly...

mapkey rd @MAPKEY_LABELInsert reference dimesnion;\

mapkey(continued) ~ Command `ProCmdViewOrient` ;~ Activate `orient`
`NmViewCheckBtn`1 ;\

mapkey(continued) ~ Select `orient` `namedviewPH.NameVw_List`1 `W`;\

mapkey(continued) ~ Activate `orient` `namedviewPH.NameVw_PB_Delete`;\

mapkey(continued) ~ Activate `orient` `OkPB`;~ Command
`ProCmdViewOrient` ;\

mapkey(continued) ~ Input `orient` `namedviewPH.NameVw_IP` `w`;\

mapkey(continued) ~ Update `orient` `namedviewPH.NameVw_IP` `w`;\

mapkey(continued) ~ Activate `orient` `namedviewPH.NameVw_PB_Save`;~
Activate `orient` `OkPB`;\

mapkey(continued) ~ Command `ProCmdViewAnnotOrient` ;~ Open
`Odui_Dlg_00` `t1.ViewChooser`;\

mapkey(continued) ~ Close `Odui_Dlg_00` `t1.ViewChooser`;\

mapkey(continued) ~ Select `Odui_Dlg_00` `t1.ViewChooser`1 `W`;\

mapkey(continued) ~ Activate `Odui_Dlg_00` `stdbtn_1`;~ Command
`ProCmdInsMenuMgr3dRefDim`;



Eric Slotty

- <">mailto:->

414-362-2552



This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.