cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - When posting, your subject should be specific and summarize your question. Here are some additional tips on asking a great question. X

Revised ArAnCa Loop (my take on the Mobius Strip)

Patriot_1776
22-Sapphire II

Revised ArAnCa Loop (my take on the Mobius Strip)

Hadn't had time until lately to investigate playing with this again.  It's a shape with a single side, and a single edge.  I managed to fix it and get nice smooth tangencies, and the exact geometry I wanted (rate of OD change, rate of unfold to refold), and make sure the unfolded width was the same length as the circular section circumference.  I just added a thickness to it so I can 3D print it.

2015-06-01_ARANCA_LOOP.jpg


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 ACCEPTED SOLUTION

Accepted Solutions

6 REPLIES 6

Nice one!

Patriot_1776
22-Sapphire II
(To:TomD.inPDX)

'Sup Antonius!  I sent you the real file via e-mail....unless it's changed.  If so, lemme know.  Hope you've been well! 

Somewhat surprised Antonius was the only one to comment on this.......

The rest of us were overwhelmed and just sat back in awe.

TomU
23-Emerald IV
(To:Dale_Rosema)

Yep, pretty much! 

LOLZ!  Geez, usually that only happens when I do something colossally stupid (again...)!! 

Top Tags