Revised ArAnCa Loop (my take on the Mobius Strip)

Hadn't had time until lately to investigate playing with this again.  It's a shape with a single side, and a single edge.  I managed to fix it and get nice smooth tangencies, and the exact geometry I wanted (rate of OD change, rate of unfold to refold), and make sure the unfolded width was the same length as the circular section circumference.  I just added a thickness to it so I can 3D print it.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.