Sketch View

[dpillow]

Almost everything we design starts with a sketch, right! So why doesen't PTC have a Sketch Orientation in the dropdown for views. Right, left, top, bottom , back, front, standard, default? I just want to get back to the sketch orientation without figureing out which view I started in. I know it not that hard to remember but why should we have to? Should be simple enough for a near future request?? Please!!!!!

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[dgschaefer]

In Creo 2 Parametic there should be a sketch view button on the far left of the sketch ribbon.

[JamesBurcham]

The button looks like this.Its been in every version of ProE/Creo since Wildfire began.

[dpillow]

Been using ProE since '98 and learn somethng new everyday. going to eye doctor to get checked. Thanks

[JamesBurcham]

Don't feel too bad about that its one of those things no one seems to teach, and not something people typically stumble onto.

[MartinHanak]

Don,

you are right, PTC model templates do not have views defined. Every user has to create your own model templates and define views inside them.

Martin Hanak