Unadapted notes for dowel pin holes

[maxpsx]

Hello everyone,

I have a problem with the hole notes that IFX creates for dowel pin. Notes mentioned a threaded hole as in attachment while it should be a smooth drilled hole with tolerance.

Could you please advise me on how to manage this issue ?

Thanks

[OliverGräbner]

Hi,

I think the information for the hole is shown correctly in general, but it is possible to customize the hole note.

For more details follow this link:

https://community.ptc.com/t5/Creo-Modeling-Questions/CALLOUT-FORMAT-in-hol-files/m-p/153980

Or directly look to the PDF from PTC.

https://community.ptc.com/t5/Creo-Modeling-Questions/CALLOUT-FORMAT-in-hol-files/m-p/153980/thread-id/38731?attachment-id=24574

Regards,
Oli

[maxpsx]

Hi Oliver,

Thanks a lot for your quick reply, I will look at it 

Thanks