cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Welding: Weld Wizard: Preparation and Solid weld

Sergey
13-Aquamarine

Welding: Weld Wizard: Preparation and Solid weld

Hello everyone.

 

I have an issue: Two pipes with straight edges (i.e. not prepared edges) are connected to each other. By using the Weld Wizard I create preparation with the following parameters: 2 mm root opening, 2.5 mm depth and bevel angle of 35°. Everything works well except that the weld being created as a surface. When I choose "Solid" in "Weld geometry type" Regeneration failure message pops up. How do I get Solid weld type?

I will appreciate some help in solving this issue. 

 

Best,

Sergey

1 ACCEPTED SOLUTION

Accepted Solutions
Sergey
13-Aquamarine
(To:Sergey)

I think that I found solution: Weld size should be equal to the pipe thickness in order to create a solid weld. 

In my opinion this is a very usefull information.

 

View solution in original post

2 REPLIES 2
Sergey
13-Aquamarine
(To:Sergey)

I think that I found solution: Weld size should be equal to the pipe thickness in order to create a solid weld. 

In my opinion this is a very usefull information.

 

Mahesh_Sharma
22-Sapphire I
(To:Sergey)

@Sergey 

Thanks for sharing the details. 

You may accept your comments on post as solution. 

Announcements