Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
Is there a possibility such that we have all the required part drawings in one place and depending on what the consumer is selecting, the part gets assembled in the background automatically?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
My only thought would be to have a family table with all the possible combinations already completed and then using parameters from the data gather from the selection process of the consumer drive you to the instance of the family table that you need. But this still requires that all of the combination have already been done up front.
