Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
It's been about 15 years since I worked on a particular set of drawings that has some of it's model details depicted as imported Iges curves.
I saw several layers of Imported (flat Iges) Features and one layer of just plane old manual Curves.
We no longer have the software that generated the original Imported Iges Curves and I'm wondering if there is a way to explode and edit the imported data and just copying and moving it around?
Any Imported Iges Curve Feature gurus out there? Any words of wisdom from the group?
Again, I'm trying to patch up an old drawing package and trying to decide to make new Curves from scratch or explode one of the Imported features and use copy paste, move and trim techniques.
I'm running Wildfire 4 M170.
Glen R Wisham EW Design and Analysis Space and Airborne Systems Raytheon Company
This message contains information that may be confidential and privileged. Unless you are the addressee (or authorized to receive mail for the addressee), you should not use, copy or disclose to anyone this message or any information contained in this message. If you have received this message in error, please so advise the sender by reply e-mail and delete this message. Thank you for your cooperation. This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
