default decimal places in sketcher and drawing
‎Jan 26, 2011
04:26 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Jan 26, 2011
04:26 PM
default decimal places in sketcher and drawing
In Wildfire 5.0, what is the easiest way to use an accuracy of 4 decimal places in the sketcher, but have all dimensions that are drawn in a drawing show up as 3 places?
In WF2.0, we used:
default_dec_places 3
sketcher_dec_places 4
to achieve this, but sketcher_dec_places has been removed in WF5.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
2D Drawing
1 REPLY 1
‎Jan 27, 2011
12:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Jan 27, 2011
12:14 AM
See the picture below Cancel that option