Community Tip - Stay updated on what is happening on the PTC Community by subscribing to PTC Community Announcements. X
Eric
Also the symbol must exist in the drawing somewhere before this will work.
&sym(symbol_name)
Dave McClinton
David.mcclinton@mckesson.com
MCAD System Admin.
McKesson Automation
Hello again,
I am sure that I have done this in the past but cannot find any notes
explaining how. What is the syntax for calling a draft symbol, maybe a
surface finish mark, from text?
Thanks in advance,
Eric Henriksen
Entegee Engineering
Davenport IA