Add a wizard into Creo Flow Analysis

[bduncan]

[RadovanMíček]

Check this picture. It should be implemented in Creo 6 (maybe 6.0.1.0.)

[bduncan]

Thanks a lot,would you share the document?

[RadovanMíček · Accepted solution]

This is only one slide regarding Creo Flow Analysis.
https://www.ptc.com/en/support/article?n=CS299466&language=en&posno=4&q=Creo%20Flow%20Analysis&Product=Creo%20Parametric&Release=6.0&source=search

[tshen]

Wizard tool is not available in Creo 6.0.1.0 yet, the plan is adding it into Creo 6.0.2.0

[DavorGranic]

Don`t see it in 6.0.2.0 either.

[RadovanMíček]

It is possible in Creo 6.0.2.0. , but you need a special update Simerics file.

Please wait for Creo 6.0.3.0 or contact PTC support.

[tshen]

Refer to technical article https://www.ptc.com/en/support/article?n=CS311282,

Flow analysis Wizard will be added into Creo 4.0 M120 and Creo 6.0.3.0