cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Can create surface but not solid with sweep blend

ptc-3542438
1-Visitor

Can create surface but not solid with sweep blend

Hi all, I am trying to design a wind turbine blade through using multiple sections (around 40) by using the swept blend feature, however this does not seem to work. When I try to use sweep blending it simply says the model failed to regenerate, yet when I use the surface blending function the model generates just fine. Can anyone help?

Thanks,

Amin


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
2 REPLIES 2

Ambiguious question. Try using the surfaces, then solidify?

Sounds like overlapping issue.

Are you sure start points and directions of each section match the others?

Announcements


Top Tags