Question
determining material properties
Hi alls,
Sometimes ago, I've seen that it was possible to make some measures on
material samples and then fill results in software.
Then, properties (Young modulus.) were calculated by software.
I can't remember where I've seen this and if it was with Mechanica
(simulate) or Ansys (or an other software).
Does someone see what I mean and can tell me where this can be found?
Thanks,
GB
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Sometimes ago, I've seen that it was possible to make some measures on
material samples and then fill results in software.
Then, properties (Young modulus.) were calculated by software.
I can't remember where I've seen this and if it was with Mechanica
(simulate) or Ansys (or an other software).
Does someone see what I mean and can tell me where this can be found?
Thanks,
GB
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.