Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
I have a spline in sketch mode where I need to add points. For the life of me I can't figure out how to add a few points.
I know I have done this in the past but with earlier versions. I'm on Creo 2 now.
Should be simple. Maybe it's a Friday thing.
Thanks for any help.
Solved! Go to Solution.
Select spline.
Right click, select modify.
At some location on the spline, right click and "Add point".
View solution in original post
That was simple. Thanks a bunch
